
hold for 2 seconds and release, triple tap, double tap, etc). Typically the button press on the Z-Wave device is a single tap, but some have special button presses (ie.

Follow the instruction of the Z-Wave device that you want to unpair. Do not use in damp, moist, and / or wet locations.Ĥ. Z-Stick Gen5 is intended for indoor use in dry locations only. Improper battery use may damage the product. Keep product and batteries away from open flames and extreme heat. The manufacturer, importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting from not following any instructions in this guide or in other materials. Failure to follow the recommendations set forth by Aeotec Limited may be dangerous or cause a violation of the law. Please read this and other device guides carefully.

There are subtle differences between Z-Stick Gen5+ and Z-Stick Gen5, you can learn more by reading the table at this page: Indicates that Z-Stick Gen5 has communicated a Z-Wave command.

AEON LABS Z STICK RESET FULL
Will only reset if RESET button is held for a full 20 seconds (followed by the confirmation LED indicator).įactory reset does not happen if released earlier than 20 seconds.Ĭonfirmation of success/communication for pair, unpair, or factory reset. Indicates that it has entered factory reset mode. The technical specifications of Z-Stick Gen5+ can be viewed at that link. This includes Raspberry Pi 4 compatibility, and native Z-Wave SmartStart and Z-Wave S2 compatibilities. Z-Stick Gen5+ offers compatibility with newer technologies than non +/plus, standard Z-Stick Gen5. Z-Stick Gen5+ (ZW090) Z-Stick Gen5+ user guide
